Flooring Products

Application Guidelines

For Use as a Urethane Release Agent:

Wipe finished surface (top) of each board with Titebond Adhesive Remover wipes prior to spreading urethane glues to ensure easy clean-up of urethane adhesives on finished wood floors. Be sure to thoroughly wash the newly installed floor once installation is complete to remove remaining adhesive remover. CAUTION: Floor will be extremely slippery with remover residue on the wood surface

For General Adhesive Removal:

1. Pull off container cover and remove and discard seal. From the center of the roll, pull up a corner of a wipe, twist to a point and thread through the hole in the underside of the cover. Replace cover tightly. Pull towel through dispensing hole and tear at perforation. Close snap-down lid to keep towels from drying out when not in use.
2. Rub area of floor that has wet or cured adhesive with a cleaning wipe in a slow circular manner. See “USER TIPS” on label for more information.
3. If adhesive has cured for more than 48 hours, lay a towel over the cured adhesive and let stand for approximately five minutes. Wipe area clean with a fresh towel to remove excess adhesive and repeat.
4. Once you have cleaned the affected area with a cleaning wipe, wipe the area with a clean, water-dampened cloth to remove any remaining remover.

Note:

If you are cleaning a floor surface, clean the affected area with a cleaning wipe; wipe the area with a clean cloth and a pre-finished floor cleaner to completely remove any oily residue and to prevent slipping.

Limitations:

Be sure NOT to scrub the surface too aggressively as this will change the look of the finish, particularly with floors. Do NOT allow excess remover to drop between floor boards. Close cap when wipes are not in use. Store this product in a clean, dry area. For additional questions or recommendations, please contact Technical Service at 1.800.347.4583 or visit us at Titebond.com.